Cable Releases for Hood or Trunk

Double Lever Cable Release Attractive machined billet aluminum construction with 2 release levers - one has an 84" cable and one a 180" cable so you can open both your hood and deck lid. Top quality aircraft cable and durable housing may be cut-to-length. Kit includes housing end caps, "no-fray" cable stops and 5 cable clamps.

Made in America by Control Cables Inc.

Single Lever Cable Release An attractive machined billet aluminum unit. Top quality aircraft cable and durable housing may be cut-to-length. Kit includes housing end cap, "no-fray" cable stop and 2 cable clamps.

Made in America by Control Cables Inc. in 2 lengths.

Or for deck lids and longer needs (4 cable clamps).

#CC-S15 (15 foot cable)

$60.00

"No-fray" end cable stop (as seen in the photo, below).

#CC-STOP (each)

$5.00

Billet Knob Cable Release A straight-forward, attractive machined billet knob with a 120" cable so you can open your hood or deck lid. Top quality aircraft cable and durable housing may be cut-to-length. Kit includes housing end cap, "no-fray" cable stop and 3 cable clamps.

Made in America by Control Cables Inc.

Also available with a solid stainless steel wire cable for push-pull applications like carb choke.

Emergency Door Release Kit Even the very best electrical entry systems could go bad. This Emergency Door Release Kit gives you the mechanical back-up way to trip the driver door latch and get into your car. Kit contains 8+ feet of encased cable, stainless steel braided door wire loom with billet ends to run the cable through and into the door, billet pull knob with set screw, cable clips and mounting hardware. Easily run into the engine compartment or under a fender well. Why leave yourself unprotected? Made in America by Itsashoka Innovations.

#TP-BKD-1...   Only

$39.00

"Neat idea guys!! Finally a street rod product that should have been introduced years ago!!!
Kelly, Texas "

---

Cable Installation Kit May be used to connect between the handle and the latch.  30" of aircraft cable.  Delrin® plastic pulley to allow some vertical offset of the handle from the latch.  Wire retainer to keep the cable in the pulley groove.  Pulley mounting hardware, cable ends and instructions. Make your life a little easier.

#L22C  (One Door as shown)

$9.95

---

Cable Installation Kit for Latch Releases Get all the pieces to help you connect your latch and latch release. 6+ feet of cable and sheathing (cut to length for 2-doors), 8 sets of plastic clips, screws and nuts. Compression sleeves (fixed end) and cable adjusters.

#B20C (for 2-doors)

$20.00